My computer turns on but no video signal is set to my monitor. I know the monitor works cause I'm typeing on it as it's plugged into an old laptop with a busted screen right now. So anyways I went through most of the problem solving steps removing all cards, trying one stick of ram, switching to the other stick...... But anyways let me continue to the point I'm at right now. I bought a new motherboard which required ddr3 ram, so new ram, new case, same old q6600 I was using and one of my two 9500's. But anyways same problem as before everything turns on but no signal to the monitor. So I'm guessing my next step is to replace the cpu unless anybody has a trick I should try first. O and yes before you ask I tried switching out my gpu's and I even tried a old 8500 i had laying around. All and any help would be welcomed.

Bump babump baaaa bump. Any help would be great guys.

have you gone into your bios and set the video output to the pcie slot?

Sometimes shit goes haywire and it defaults back to the onboard videoo.
If your monitor support Vga and dvi i reccomend you try the other type.
Borrow a friends monitor if possible to check it out.
If everything comes out good i say replace the cpu and GPU

Already did everything you said I have two monitors and they both work. Hooked my xbox up to both of them. Tried both types of cables. Well the only thing I haven't done was was try is to change the bios cause I can't get to them or see them.